Installation method

Video for Installation method

Installation procedures

•  

  1Preparation for installation

  • Plan the best layout for the floor heating pipe
  • Clean the floor
  • Lay the insulation sheets if required
•  

  2Install the bottom panels of HOYA ONDOL

  • Start laying the panels. Lay panels side by side along the edge of a wall in the most appropriate orientation.
  • Continue to lay panels across the rest of the floor.

  ※ Note: Take care to align panels accurately.

•  

  3Install the Pex(PE-RT) pipe

  • The size of the pipe is 12mm(ID) and 16mm(OD).
  • Roll out the pipe pushing it into the channels of the bottom panels
  • Unroll the pipe hand over hand to avoid twisting
  • Do not kink the pipe by trying to make a very tight turn.
  • The pipe should run start and finish at the manifold, by fitting the manifold in place before laying the pipe. Allow sufficient pipe for cutting and fitting at a later stage
•  

  4Install the top panels of HOYA ONDOL

  • Snap-fit the top and bottom panels
  • Use the rubber mallet hammer for easy work
•  

  5Connect the pipes to the manifold

  • Connect the pipes to the manifold by using coupling sockets
  • Be careful not to kink the pipes
•  

  6Connect the boiler

  • Connect the manifold to the boiler by certified engineer according to the local regulation.
•  

  7Completion of installation

  • Commissioning
•  

  8Install the flooring material